• 100 Watts RMS per output (4 Ohm)
• 85 Watts RMS per output (8 Ohm)
• 200 Watts RMS into 70 Volt (8 Ohm)
• 1/4" and RCA inputs
• Fault Protected Output Stage

The RA2100B is intended for professional audio and distributed musical applications. The unit also features MOSFET drivers in a voltage and current gain circuit and a one-second input turn-on delay. The RA2100B will drive 25 Volt speaker lines directly from each channel, or 70 Volt lines bridged.

• Small size with mounting tabs
• Balanced and Unbalanced Inputs
• Phoenix type input and output
• Low cost, helps win your bid
• Optical Limiter for maximum clean power output
• Bridge switch for 40W mono operation
• Included 24 VDC inline IEC power supply

• Power Output, Stereo: 100 Watts RMS/ch. 4 ohms, 70 Watts RMS/ch. 8 ohms
• Bridged: 200 Watts RMS 8 ohms
• Input Connectors: 1/4" TRS balanced and RCA
• Output Connectors: Binding posts
• Sensitivity: <1 VRMS for full output
• THD: <.08% (1kHz @ 1 Watt)
• S/N Ratio: 106 dBU
• Power Bandwidth: DC - 30 kHz +/- 1dB
• Damping Factor: > 150
• Slew Rate: 100 Volts/microSecond
• Phase Shift: <10 Deg., 20Hz - 20kHz
• Input Impedance: 10 K ohms Balanced
• Power: 120 VAC 60Hz 2.5A, 230 VAC 50Hz
• Size: 19" x 3.5" x 7.5" (48 x 9 x 19 cm)
• Weight: 12 lbs (5.5 kg)
• MOSFET drivers in a voltage and current gain circuit
• 1 second turn-on delay
• LED clip indicators for each channel
• Fault protected outputs

• Load: Page/Music 4 Ohms 20% pwr cycle
• Frequency Response: 5 Hz - 40 kHz
• Input Impedance: 47 K Ohms
• Equiv. In Noise: 100 mV typical, A Weighted, 600 Ohms
• Gain: 34 dB
• S/N Ratio: 114 dB @ 35 Watts
• 35W/ch 4ohm 30W/ch 8ohm
• Size: 19" x 1.75" x 5" (48 x 4.5 x 12.7 cm)
• Weight: 5.5 lbs (2.5 kg)
• Power: 120 VAC 50-60 Hz
• 35 Watts per channel of clean amplification
• 1/4" and RCA inputs
• Convenient spring-loaded output terminals
• Front panel heat sinking for proper venting
• Protected output stage